When your windshield has been damaged beyond repair, its best if you let go and replace car windshield instead of trying to patch things up as your expenses begin to pile up. If you think you need to get someone else to help you replace car windshield for your vehicle, you are wrong.
You can replace it on your own, as long as you know the proper steps and guidelines in removing the old windshield and replacing it with the new one that you’ve just bought. To avoid complications in the future, it would be best if you get the windshield that’s exactly for the model and make of your vehicle. When you finally have it on hand, you can now start with the process of replacing your car’s windshield.
The first thing that you need to remember if you want to replace car windshield is that you should first remove everything else in your car that is unnecessary. This way, you’ll have more room to work on and you won’t have any hindrances as you try to fix things up.
You also need to remove your rear view mirror, the windshield wipers, and other items that could be attached to your vehicle’s windshield. Once you’ve removed all of these, you need to seal the interior vents with a masking tape or a duct tape. This way, no broken glass will stray and fall into these vents that could cause you more problems in the near future.
First off, you need to check if the gasket of the windshield has no problems. If it’s cracked or is already hard, you should just cut it away and replace it. With a strong knife, you can cut the rubber away around, and just push the glass from the outside.
Now to replace car windshield, you should first prepare the frame before you reinstall the glass, make sure that there’s no more rust or dirt, and remove the sealant from the new gasket that you’ve bought. You can now fit the gasket on the new windshield that you have specifically for your car. Put a sealant at the bottom half of the gasket.
You should first rub petroleum jelly on the outer groove of the gasket, and run a nylon cord or small rope on the outer groove with enough ends that you can pull. To replace car windshield, you can lay it outside of the car, right at the spot you’ll be putting it, with the loose cords on the inside.
Now you can pull one end of the cord out slowly across the whole frame, and what this does is it puts the rubber lip in place. Once you’re replacing car windshield, you can now clean up the extra jelly, and reinstall whatever it is that you’ve removed from the start.